Mounting instructions
Mounting sequence:
The mounting sequence can deviate from the
described method depending on the structural
conditions and installation situation! The technician
is responsible for flawless and clean installation!
The channel pieces may be finished at the intended
positions only using a dovetail saw.
Preparing the counter section:
The section is prepared in accordance with
the above mentioned dimensions depending
on flush mounting or top mounting.
Note:
It is recommended that the fold is countersunk
less deep for plastic and wooden counters.
Or the hobs are mounted with some
protrusion so that hot pots/pans are not
placed on the counter surface inadvertently.
The milled-edge must be trimmed if
necessary for accurate flush mounting of
stone counters.
Place the kitchen cupboards at the intended
positions.
Now position the base fan at the desired
position.
When positioning, pay attention to the
direction of the exhaust opening.
If a 600 mm deep kitchen counter is available
in the smallest possible installation space,
ensure that the exhaust opening points to
the left.
39
GB