Assembly - RIDGID R4020 Manual Del Operador

ASSEMBLY

UNPACKING
See Figure 5.
This product requires assembly.
 Carefully lift the saw from the carton and place on a level
work surface.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
NOTE: Most the Loose Parts are stored in the water
reservoir.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in acci-
dental starting and possible serious personal injury.
MOUNTING HOLES
The tile saw can be mounted to a firm supporting surface
such as a workbench. Four bolt holes have been provided in
the saw's base for this purpose. Each of the four mounting
holes should be bolted securely using 3/8 in. machine bolts,
lock washers, and hex nuts (not included). Bolts should be of
sufficient length to accommodate the saw base, lock wash-
ers, hex nuts, and the thickness of the workbench. Tighten
all four bolts securely.
Carefully check the workbench after mounting to make
sure that no movement can occur during use. If any tipping,
sliding, or walking is noted, secure the workbench to the
floor before operating.
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 7 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no
load speed of this tool. Failure to heed this warning
could result in personal injury. Do not use wheel
with cracks, gaps, or teeth.
INSTALLING THE TILE CUTTING WHEEL
See Figure 6.
WARNING:
A 7 in. tile cutting wheel is the maximum wheel
capacity of the saw. Never use a wheel that is too
thick to allow wheel washer to engage with the
flats on the spindle. Larger wheels will come in
contact with the splash hood, while thicker wheels
will prevent the wheel bolt from securing the wheel
on the spindle. Either of these situations could
result in a serious accident and can cause serious
personal injury.
ARBOR
12 — English
TILE CUTTING
WHEEL
INNER
WASHER
OUTER
WASHER
ARBOR
NUT
Fig. 6