RIDGID R4020 Manual Del Operador página 14

ASSEMBLY
INSTALLING THE RIP GUIDE
See Figure 9.
 Place the front of the rip guide on the front rail of the saw
table.
 Lower the back of the rip guide to the saw table.
 Use the rip guide scale, located on front of the table, to
set the rip guide to the desired width of cut.
 Push the locking lever down to secure to the saw table.
When securely locked, the locking lever should point
downward.
INSTALLING THE MITER GUIDE
See Figure 9.
 Align the grooves under the miter guide with the grooves
in the top of the rip guide.
 Push the miter guide onto the rip guide to the desired
operating position.
NOTE: Slide the guide off the rip guide to remove.
INSTALLING THE OVERFLOW DRAIN
See Figure 10.
 Firmly push the overflow drain into the hole in the bottom
of the water fill reservoir.
FILLING/CHANGING THE WATER RESERVOIR
See Figure 11.
 Fill the water reservoir with clean tap water to the fill line.
NOTE: The overflow drain prevents overfilling.
To change reservoir water:
 Unplug the saw.
 Remove the overflow drain and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
 Rinse the machine thoroughly.
 Discard the waste water in accordance with local regula-
tions.
 Replace with clean water.
LOCKING
LEVER
MITER
GUIDE
14 — English
RIP
GUIDE
FILL LINE
Fig. 9
OVERFLOW
DRAIN
Fig. 10
WATER
RESERVOIR
Fig. 11