Simplicity Regent Serie Manual Del Operador página 14

Ocultar thumbs Ver también para Regent Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
Engines give off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause
nausea, fainting or death.
Start and run engine outdoors.
Do not start or run engine in enclosed area, even if
doors or windows are open.
1. Sit in the seat and lift UP the seat adjustment lever, po-
sition the seat as desired, and release the lever to lock
the seat in position.
2. Fully depress the brake pedal or set the parking brake
with pedal fully depressed, pull UP on parking brake
knob, then release pedal.
3. Disengage PTO switch by pushing IN.
4. Set the throttle/choke control to the CHOKE position.
5. Insert the ignition key and turn clockwise to the START
position and release the key as soon as the engine
starts.
6. After the engine starts, move the throttle/choke control
to half speed. Warm up the engine by running it for at
least 30 seconds.
7. Set throttle/choke control to the FAST position.
NOTE: In the event of an emergency, the engine can be
stopped by turning the ignition switch to STOP. For nor-
mal engine shut down, follow the procedure in "Stopping
the Tractor & Engine."
Driving the Tractor
1. Sit in the seat and adjust the seat so that you can com-
fortably reach all the controls and see the dashboard
display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see Starting the Engine).
5. Disengage the parking brake and release the brake
pedal.
6. Depress the forward ground speed control pedal to
travel forward. Release the pedal to stop. Note that the
further down the pedal is depressed the faster the trac-
tor will travel.
7. Stop the tractor by releasing the ground speed control
pedals, setting the parking brake, and stopping the en-
gine (see Stopping the Tractor and Engine).
14
Mowing
1. Set the mower cutting height to the desired level using
the mower lift lever.
2. Engage the parking brake. Make sure the PTO switch is
disengaged.
3. Start the engine (see Starting the Engine).
4. Set the throttle/choke control to the FAST position.
5. Engage the PTO to activate the mower blades.
6. Begin mowing.
7. When fi nished, shut off the PTO and raise the deck
using the mower lift lever.
8. Stop the engine (see Stopping the Tractor and
Engine).
WARNING
The engine will shut off if the reverse ground speed
pedal is depressed while the PTO is on and the
RMO has not been activated. The operator should
always turn the PTO off prior to driving across
on roads, paths or any area that maybe used by
other vehicles. Sudden loss of drive could create a
hazard.
WARNING
Mowing in reverse can be hazardous to bystanders.
Tragic accidents can occur if the operator is not
alert to the presence of children. Never activate
RMO if children are present. Children are often
attracted to the unit and the mowing activity.
Mowing in Reverse (RMO)
If an operator chooses to mow in reverse, the RMO sys-
tem can be used. To use the Reverse Mowing Option
(RMO) turn the RMO key after the PTO is engaged. The
L.E.D. light will illuminate, and the operator can then mow
in reverse. Each time the PTO is engaged the RMO needs
to be reactivated if desired. The key should be removed
to restrict access to the RMO feature.

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

26910132691102-001695129

Tabla de contenido