Specifi Cations - Simplicity Regent Serie Manual Del Operador

ENGINE
Briggs & Stratton
Model Professional Series™
Horsepower 21 Gross HP @ 3500 +/- 100 rpm
Displacement 32.95 cu in. (540 cc)
Electrical System Alternator: 9A Reg.
Battery: 12 Volt, 195 CCA
Oil Capacity 48 oz (1,4 L)
Briggs & Stratton
Model Professional Series™
Horsepower 22 Gross HP @ 3600 +/- 100 rpm
Displacement 40.03 cu in. (656 cc)
Electrical System Alternator: 9A Reg.
Battery: 12 Volt, 230 CCA
Oil Capacity 64 oz (1,9 L)
CHASSIS
Fuel Tank Capacity 3.5 gal (13,2 L)
Front Wheels Tire Size: 15 x 6,0-6
Infl ation Pressure: 12-14 psi (0,82-0,96 bar)
Rear Wheels Tire Size: 20 x 8,0-8
Infl ation Pressure: 10 psi (0,68 bar)
Power Rating
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive En-
gineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and
corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values
are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net power val-
ues are taken with exhaust and air cleaner installed whereas gross power values are collected without these attachments.
Actual gross engine power will be higher than net engine power and is aff ected by, among other things, ambient operating
conditions and engine-to-engine variability. Given the wide array of products on which engines are placed, the gas engine
may not develop the rated gross power when used in a given piece of power equipment. This diff erence is due to a variety
of factors including, but not limited to, the variety of engine components (air cleaner, exhaust, charging, cooling, carburetor,
fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine
variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power
for this Series engine.
Parts and Accessories
See an authorized dealer.
TRANSMISSION
Type Hydrostatic Tuff Torq K46Z
Engine Oil 10w 30 Premium Engine Oil
Speeds Forward: 0-5.5 MPH (0-9,0 km/h)
@ 3400 rpm Reverse: 0-3.0 MPH (0-4,6 km/h)
Continuous Torque 170 ft-lbs (230,5 Nm)
Output
MOWER
Width of Cut 38" (96,5 cm)
Number of Blades 2
Base Deck Platform Side Discharge
Cutting Height 1.0-4.0 in. (2,5-10,2 cm)
Cutting Positions Infi nite
Specifi cations
21