Side Skids; Rear Rakes; Stopping The Machine; Parking - breviglieri turbo t 120 sr Serie Instrucciones De Empleo Y Mantenimiento

particularly the spacers (Fig. 7). Make sure that the new tines and components are assembled in the same positions.
▪
Check the bolts and self-locking nuts for wear and replace them if necessary.
It is advisable to replace the tool bolt whenever the tools are partially or completely replaced. This prevents bolts that have
lost their mechanical strength owing to wear, from breaking.
It is essential to replace the tools with genuine spares in order to ensure that the rotor is correctly balanced.
It is strictly forbidden to clean the machine whilst it is operating if the rotor becomes clogged. First disengage the PTO,
stop the tractor and apply the parking brake. Wait until all moving parts have come to a complete standstill and only then

4.5.1 SIDE SKIDS

The side skids (8 Fig. 1) can be applied to the sides of the cutter and set a fixed cutting height established by the Manufacturer.
They are used to mow grass on lawns where a uniform cut is required.

4.5.2 REAR RAKES

This accessory can be applied to any type of cutter. It is used when the plants must be shredded to a finer degree (Fig. 8). It is fitted
in place of the rear hood. The rakes must never dig into the soil since their purpose is to hold back the cut plants so that they can
be shredded further before being unloaded.

4.6 STOPPING THE MACHINE

At the end of the job, the operator must:
▪
Disengage the tractor PTO
▪
Lower the machine to the ground
▪
Stop the tractor and engage the parking brake
▪
Make sure that all parts of the machine have come to a standstill
Only after the above mentioned operations have been carried out may the operator leave the tractor unattended.

4.6.1 PARKING

To park the machine and unhitch it from the tractor, the operator must:
▪
Make sure that no one is standing or crossing the place where the machine will be parked
▪
Make sure that the place in which the machine is to be parked is suitable, flat and uncluttered
▪
Drive to the area where the machine is to be unhitched
▪
Brake the tractor
▪
Lower the bearing stands
▪
Completely lower the machine to the ground
▪
Stop the tractor and engage the parking brake
▪
With the tractor stopped, its engine off and the components at a complete standstill, operate the levers of the hydraulic
circuit so as to relieve the pressure from inside the pipes. This will allow you to re-connect the quick couplings with greater
ease
▪
Disconnect the quick couplings
▪
Remove the driveline from the tractor's PTO and rest it on its bracket
▪
Disconnect the top link rod
▪
Disconnect the power lift links
▪
Switch on the tractor engine and move away
proceed with the cleaning operations using the utmost caution.
The place in which the machine is parked must be:
DANGER
WARNING
- 33 -
turbo t 120 sr