Belt Replacement And Tension Adjustment; Lubrication; Recommended Lubricants; After The First 8 Hours Service - breviglieri turbo t 120 sr Serie Instrucciones De Empleo Y Mantenimiento

5.1.1 BELT REPLACEMENT AND TENSION ADJUSTMENT

The belts are correctly tightened when they give max 6-8 mm (Fig. 8).
Proceed in the following way to replace the belts and adjust their tension:
▪
Remove the screws and take off the protective casing
▪
Loosen the screws on the gearbox support
▪
Work on the nuts until the belts have been tightened to the correct degree
▪
Tighten the nuts
▪
Tighten the screws
▪
Fit the casing back in position and fasten it with the screws
If the belts are changed, they must all be replaced with others of the same size. This will ensure that
the transmission always operates in a fully efficient way.

5.2 LUBRICATION

Lubrication of any machine with parts that turn and/or rub together is a vitally important task for the life and functionality of the
actual machine itself. Lubrication must therefore be carried out systematically and at the required intervals. The frequencies given
refer to machine use in a normal environment. If this machine is used in heavier duty conditions, it must naturally be lubricated
more frequently.

5.2.1 RECOMMENDED LUBRICANTS

▪
It is advisable to lubricate the overdrive with: SAE 85W/140 OIL, complying with API-GL5/MIL-L-2105C specifications.
▪
For all greasing points, the Manufacturer recommends: LITHIUM GREASE.
When servicing the driveline, strictly comply with the instructions given by the driveline Manufacturer, in the specific operation
and maintenance manual with which each driveline is equipped.

5.2.2 AFTER THE FIRST 8 HOURS SERVICE

Each new machine must be checked after the first 8 hours service. Proceed in the following way:
▪
Check the general condition of the machine
▪
Make sure that all the screws are well tightened
- 35 -
turbo t 120 sr
Fig. 8