Sanus VMT5 Manual De Instrucciones página 13

4. Place the wall plate template
template and tape in place.
10
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the middle two pilot holes (into the stud) using a 5.5 mm (7/32 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 89 mm (3 1/2 in.).
Drill the outer top two pilot holes (into the drywall) using a 10 mm (3/8 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 25 mm (1 in.).
4
at your desired height and position the middle holes over your stud center lines. Level the wall plate
10
10
5
.)
( 3 / 8 i n
1 0 m m
2 i n .)
m ( 7 / 3
5 .5 m
2 i n .)
m ( 7 / 3
5 .5 m
25 mm
(1 in.)
10 mm
(3/8 in.)
.)
( 3 / 8 i n
1 0 m m
89 mm
(3 1/2 in.)
10
5.5 mm
(7/32 in.)
13