Stihl FS 110 Manual De Instrucciones página 28

English
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
1
Screw the mowing head
N
counterclockwise on to the shaft (1)
as far as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Unscrew the mowing head
N
clockwise.
26
Mounting Metal Cutting Attachment
Keep the leaflet and packaging of the
metal cutting tool in a safe place.
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only metal cutting attachments.
Check direction of rotation of cutting
attachment
Cutting attachments with 3 or 4 teeth (1,
3) may point in either direction – these
cutting attachments must be turned over
regularly to help avoid one-sided wear.
The cutting edges of cutting
attachments 2, 4 and 5 must point
clockwise.
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
Place the cutting attachment (6) on
N
the thrust plate (7).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
Fit the thrust washer (8) – convex
N
side must face up.
Fit the rider plate (9).
N
Block the shaft (10).
N
Use the combination wrench (12) to
N
screw the mounting nut (11) on to
the output shaft counterclockwise
and tighten it down firmly.
FS 110, FS 110 R