RIB SUPER 2200 FAST FCE Manual Del Usuario página 36

G
B
ACCESSORIES -
PLATE TO BE CEMENTED
BLOCK
BLOCK KEY SELECTOR FOR WALL-INSTALLATION
BLOCK KEY SELECTOR TO BUILA-IN
SPARK
In order to make the systems mentioned above give the best performances, you need to
install an antenna tuned on the frequency of the radio receiver installed.
N.B. Pay attention to not let the central wire of the cable to came Into contact with
the external copper sheath, since this would prevent the antenna from working.
Install the antenna vertically and in such a way the remote control can reach it.
SPARK BLINKER WITH IN-BUILT INTERMITTENT CARD
LATERAL SUPPORT
SPARK ANTENNA 433
PROBE
The probe detects the motor temperature to operate the heating system under low
temperature conditions, up to -30°C (connect to connector J6).
For the connections and the technical data of the optional equipments follow the relevant handbooks.
code ACG8103
code ACG1053
code ACG1048
code ACG7059
code ACG7042
code ACG5452
code ACG4665
RACK MODULE 4
with zinc plated angle Iron, in 2 m bars.
RADIO TRANSMITTER SUN
SUN 2CH cod. ACG6052
SUN CLONE 2CH cod. ACG6056
FIT SYNCRO
FIT SYNCRO PHOTOCELLS for the wall-installation
The range you can set is 10-20 m, 30÷60ft.
You can fit many couples close together thanks to the synchronising circuit.
Add the SYNCRO TRANSMITTER
for more than 2 photocells couples (up to 4).
COUPLE OF BUILT-IN BOXES FOR THE FIT SYNCRO
PAIR OF COLUMNS FOR FIT SYNCRO
36
code ACS9050
SUN 4CH cod. ACG6054
SUN CLONE 4CH cod. ACG6058
code ACG8026
code ACG8028
code ACG8051
H = 0,5 m code ACG8057