Unpacking The Generator; Overview Of The Generator - Parker HPN2-5000 Manual De Instrucciones

2.6.2 Unpacking the Generator

Once ready to install, remove the equipment from the packaging and check for signs of damage. Verify that the items listed in the table below
have been shipped with the generator.
Description
1/8" BSPP - 1/4" Tube Fitting
1/8" BSPP Exhaust Silencer
Dowty Seal
MIST-X Silencer Kit
UK electrical supply cable
European electrical supply cable
USA electrical supply cable
(1) The UK and European cables are supplied with the 230 Vac rated generators, and the USA cable is supplied with the 120 Vac rated generators.
If any items are missing or damaged please contact your local Parker office. Do not attempt to power up the generator.

2.6.3 Overview of the Generator

Key:
1 Pressure Relief Valve (Compressor version only)
2 Column Inlet pressure gauge (Non compressor version only)
3 Receiver pressure gauge
N Outlet pressure gauge
4
2
N Outlet pressure regulator
5
2
N Mass Flow Controller bypass valve.
6
2
Note. Items 1 and 5 are preset at the factory and should not be adjusted. The pressure gauges are supplied for diagnostic and indication
purposes only.
6
HPN2 HPN2
5000 5000C
1 1
1 1
2 1
1 1
(1)
1 1
1 1
1 1
7
8
9
10
11
12
13
HPN2 HPN2 HPN2
7000 7000C 10000
1 1 1
1 1 1
2 1 2
1 1 1
1 1 1
1 1 1
1 1 1
Control Panel
Fused IEC320 Inlet Socket and power switch
Remote switching and MODBUS interface
MFC N Outlet Port
2
N Outlet Port
2
Compressed Air Inlet Port (Non compressor version only)
Drain Port
HPN2 HPN2 HPN2
10000C 12500 12500C
1 1 1
1 1 1
1 2 1
1 1 1
1 1 1
1 1 1
1 1 1