EAS ELECTRIC EMD12X3-V1 Manual De Instrucciones página 71

Step 4. Dishwasher installation steps
Please refer to the specified installation steps
in the installation drawings.
1. Affix the condensation strip under the work surface of cabinet.
Please ensure the condensation strip is flush with edge of work
surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position. (Step 4)
6. Level the dishwasher. The rear foot can be adjusted from the
front of the dishwasher by turning the Philips screw in the middle
of the base of dishwasher use an Philips screw. To adjust the front
feet, use a flat screw driver and turn the front feet until the
dishwasher is level. (Step 5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher. (Step
7 to Step 10)
8. Adjust the tension of the door springs by using an Allen key
turning in a clockwise motion to tighten the left and right door
springs. Failure to do this could cause damage to your dishwasher.
(Step 11)
9. The dishwasher must be secured in place. Fix the side with screws.
9
23
V.2