Start Up - Truper ROTO-1/2NX2 Instructivo

Start Up

Bit Fitting
• Put the bit into the chuck until it stops. Fasten with the
chuck wrench and tighten alternately the chuck into each
of the orifices.
WARNING
Clean off the bit and chuck burrs and
any other debris. Otherwise the bit would not be
properly fastened and cause severe personal injury.
Turn on and operation control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (A) to start the hammer drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
Speed level selection
• The tool speed can be selected with the speed selector (C) on the tool side.
• For low speed keep selector in number one (1), oriented towards the tool front.
• For a higher speed keep selector on number two (2) oriented towards the front of
the tool.
• Changing the speed ratio as described below does not affect the possibility of
controlling each ratio.
CAUTION
Do not turn the speed selector while the tool is running.
Speed control
• The tool can run in different speeds. Select by adjusting speed control (D) in the
switch.
• Turn speed control clockwise to increase the hammer drill speed and torsion.
• Turn counterclockwise to lessen speed and torsion.
Changing from hammer drill to drill
• To drill concrete, floor tile or materials of similar hardness, move the impact-rotation selector
(E) completely into the IMPACT position (pointing towards
impact and rotate onto the material.
• To drill metal, wood or plastic, move the impact-rotation selector completely into the
ROTATION position (pointing towards
WARNING Do not try to drill metal; wood or plastic with the hammer drill into IMPACT
(pointing towards ) mode setting. Otherwise the tool efficiency will lessen and the bit tip
would get damaged.
Rotation direction
• To get the bit to rotate forward and drill, move the rotation selector lever (F)
towards the arrow pointing the chuck.
• To get the bit go reverse and use the tool as a screwdriver, move the rotation
selector lever towards the arrow pointing the hammer drill handle.
WARNING Never use the tool in reverse when the impact-rotation selector is
in the IMPACT (pointing towards
severely damaged.
Bit
2
2
). The bit will simultaneously
). The bit will rotate onto the material.
) position, otherwise, the impact system will be
Chuck
Chuck
wrench
B
2
A
C
2
D
E
Rotation selector lever
in the drilling position
F
Switch
ENGLISH
7