Start Up - Truper ROTO-1/2A8 Manual De Instrucciones

Start Up

Bit fitting
• Put the bit into the chuck until it stops.
Fasten with the chuck wrench and tighten
alternately the chuck into each of the orifices.
Turn on and operation control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (A) to start the hammer drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
Speed control
• The tool can run in different speeds. Select by adjusting
speed control (C) in the switch.
• Turn speed control clockwise to increase the hammer
drill speed and torsion.
• Turn counterclockwise to lessen speed and torsion.
Changing from hammer drill to drill
• To drill concrete, floor tile or materials of similar
hardness, turn the impact-rotation selector (D) completely
into the IMPACT ( ) position (pointing towards the
chuck). The bit will simultaneously impact and rotate onto
the material.
• To drill metal, wood or plastic, move the impact-rotation
selector completely into the ROTATION (
(pointing towards the chuck). The bit will rotate onto the
material.
WARNING Do not try to drill metal; wood or
plastic with the hammer drill into IMPACT (
setting. Otherwise the tool efficiency will lessen and the
bit tip would get damaged.
Rotation direction
• The rotation direction button is located on both sides of
the hammer drill (E).
• To make the drill turning forwards and drill, press the
rotation direction button with the arrow pointing towards
the chuck.
• To make it reversible press the rotation direction button
with the arrow pointing towards the hammer drill handle.
• The reverse rotation enables the hammer drill to loosen
screws and nuts turning the hammer drill into a
screwdriver. When using the hammer drill in the
screwdriver mode do not exercise too much pressure onto
the switch.
• Changing the rotation direction can only be carried out
when the switch is not pressed.
Bit
) position
) mode
Chuck
Chuck
wrench
B
C
A
D
Rotation selector
button in the
drilling position.
ENGLISH
E
7