Maintenance - Truper TAL-1/2N Manual De Instrucciones

Chuck change
• Remove the auxiliary handle and open the chuck jaws.
• Using a screwdriver remove the left-threaded safety
screw with a clockwise movement.
• Fit the long side of a Hex key (not included) in a vise and
insert the short side of the Hex key (not included) to the
chuck. Close the jaws.
• Move the rotation selector button (C) into the reverse
position (see page 7, Rotation direction) and fastening with
a firm hand activate the drill. The chuck will be released
with the turn.
• Set the new chuck turning it into the drill thread until it
stops.
• Open fully the jaws and set the screw threading
counter-clockwise. Tighten with a screwdriver.
Cleaning and care
• To guarantee an adequate motor cooling, always keep
slots clean and free of obstructions.
• Regularly inspect all the mounting screws. Double-check
they are properly tighten. If any screw is loose tighten
immediately.
Service
• Service should only be made in a
Authorized Service Center. Service and maintenance
performed by non-qualified people may be dangerous and
lead to personal injuries. It also makes the product
Warranty void.
Carbon brush replacement
• Carbon brushes should be checked periodically.
• When one or both carbon brushes show signs of wear go
to a Authorized Service center to have
both carbon brushes replaced. When replaced, see if the
new carbon brushes move freely in the carbon brush
housing. Ask to turn on the tool during five minutes to
make the contact in the carbon brushes and the commuter
even.
• Use only original
brushes, designed specifically with the right strength and
electric resistance for each type of motor. Carbon brushes
with different specifications may damage the motor.
• When replacing carbon brushes, always change both.
8
ENGLISH
spare carbon

Maintenance

Phillips
screwdriver
Vise
Lubrication
• We recommend lubricating the tool transmission every
carbon brush change in a
Service Center.
C
Rotation selector button
in the reverse position.
Authorized