Dremel 9100 Instrucciones De Funcionamiento Y Seguridad página 11

2610Z04970.qxp_9100 1/30/17 10:59 AM Page 11
outlet. Always plug the motor unit into the
MOUNTING THE MOTOR UNIT
1. To mount the motor unit, start by securely
fastening the mounting bracket to a wooden
structure with two(2) #8x1.5" wood screws.
2. Hang the motor unit on the bracket by
placing the tool hanger in the hook on the
mounting bracket.
TO DRYWALL OR PEGBOARD. Mounting
area not strong enough to support the motor
unit leading to personal injury or property
damage.
INSTALLING AND REMOVING
ACCESSORIES FROM HAND PIECE
WITH 3 JAW CHUCK
(Not included in all kits)
1 Unplug tool from power source.
2. To install an accessory, open the 3 jaw chuck
as far as necessary by rotating the chuck key
counter clockwise.
3. Insert the accessory fully into the chuck to
minimize runout and unbalance.
4. Turn the chuck key clockwise to tighten the
jaws and secure and center the accessory.
5. If the accessory does not run true, reopen
the jaws, rotate the accessory ¼ turn and
retighten.
Do not plug the motor
unit directly into wall
DO NOT ATTACH
MOUNTING BRACKET
output connector of the Variable Speed
Foot Pedal. Operating accessory beyond its
speed rating will cause severe injury.
FIG. 5
FIG. 6
6. To remove an accessory, simply open the
jaws by turning the key counterclockwise and
pull out accessory.
FIG. 7
3x
11