Installing The Light Kit 8 - Progress Lighting AirPro P2552 Manual De Instalación

CAUTION:
Before starting
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1. While holding the light plate under your
fan, locate two single white and blue wires in the
switch housing labeled FOR LIGHT. Make the
polarized plug connections: (Fig. 14)
- White to white
- Blue to black
Step 2. Carefully push all wires back into the
switch housing, then install the light plate onto
the switch housing with 3 screws provided. Be
sure to tighten all screws. (Fig. 14)
Step 3. Install the 10W LED bulb (included).
(Fig. 15)
Step 4. Raise glass shade up against the light kit
and secure it to fan by turning glass clockwise
until snug. DO NOT OVERTIGHTEN. (Fig. 15)
Step 5. Restore power and your light kit is ready
for operation.
installation,
Wire connector
Light kit
Figure 14
Switch housing
Screws
Figure 15

Installing the Light Kit 8.

Light kit
Bulb
Glass
shade