Installing The Light Kit; Installing The Battery - Progress Lighting AirPro P2550 Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION:
Before
starting
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove the 1 of 3 screws from the posts
of the mounting ring and keep it for future use.
Loosen the other 2 screws. (Do not remove) (Fig.
13)
Step 2. While holding the LED light kit under
your fan, make the polarized plug connections:
- Blue to white
- Black to black
Step 3. Place the key holes in the LED light kit
over the two screws previously loosened from the
mounting ring. Turn the LED light kit until the
LED light kit locks in place at the narrow section
of the key holes. (Fig. 13)
Step 4. Securely tighten the two light kit
mounting screws previously loosened and the one
previously removed. (Fig. 13)
Step 5. Raise glass shade up against the LED
light kit, and secure it to fan by turning glass
clockwise until snug. DO NOT OVERTIGHTEN.
(Fig. 13)
9.

Installing the Light Kit

installation,
Wire connector
LED
Light kit
Figure 13

Installing the battery

Install a 12V MN21/A23 battery (included) into the
remote control. To prevent damage to the remote
control, remove the battery if not used for long
periods. (Fig. 14)
Mounting
ring
Screws
Glass
shade
Figure 14
ON ECE
1 2 3 4

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido