Installing The Switch Housing - Progress Lighting AirPro P250016 Manual De Instrucciones

Before starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
1. While holding the switch housing under your
fan, snap together the wire connector plug.
2. Carefully push all wires back into the switch
housing, then install the switch housing onto the
mounting plate with 3 screws provided. Be sure to
tighten all screws. (Fig. 14)
installation,
Wire connector
Switch
houaing
Figure 14

Installing the Switch Housing

Mounting
plate
Screws
8.