Installing The Battery; Installing The Light Kit - Progress Lighting AirPro P2548 Manual De Instalación

Before starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove the 1 of 3 screws from the posts
of the mounting plate and keep it for future use.
Loosen the other 2 screws. (Do not remove) (Fig.
13)
Step 2. While holding the LED light kit under
your fan, make the polarized plug connections:
- Blue to white
- Black to black
Step 3. Place the key holes in the LED light kit
over the two screws previously loosened from the
mounting plate. Turn the LED light kit until the
LED light kit locks in place at the narrow section
of the key holes. (Fig. 13)
Step 4. Securely tighten the two light kit
mounting
screws previously loosened and the one
previously removed. (Fig. 13)
Step 5. Raise glass shade up against the LED
light kit, and secure it to fan by turning glass
clockwise until snug. DO NOT OVERTIGHTEN.
(Fig. 13)
installation,
Wire connector
LED light Kit
Figure 13

Installing the battery

Install 9 volt battery (included), to prevent damage
to transmitter, remove the battery if not used for
long periods.
Mounting plate
Screws
Glass
shade
Figure 14

Installing the Light Kit

8.