Installing The Decorative Cover - Progress Lighting AirPro P250010 Manual De Instalación

CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Step 1. Remove the 1 of 3 screws from the
posts of the mounting plate and keep it for
future use. Loosen the other 2 screws. (Do not
remove)
Step 2. Place the key holes in the decorative
cover over the two screws previously
loosened from the mounting plate. Turn the
decorative cover until the decorative cover
locks in place at the narrow section of the key
holes. (Fig. 16)
Step 3. Securely tighten the two mounting
screws previously loosened and the one
previously removed.
Step 4. Fit the decorative nut onto the
decorative cover.
9.

Installing the Decorative Cover

Mounting
plate
Decorative
cover
Decorative
nut
Figure 16
Installing the battery
Install a 12V battery (included) into the remote
control. To prevent damage to the remote control,
remove the battery if not used for long periods. (Fig.
17)
Screws
Figure 17