Assembly; Fitting The Loop Handle; Assembling The Cutting Equipment - Husqvarna 224L Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fitting the loop handle

Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
Slide the spacer into the slot in the loop handle.
Fit the nut, washer and screw. Do not overtighten.
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Assembling the cutting
equipment
WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
1155650-49 Rev. 3 2016-11-08

ASSEMBLY

Fitting other guards and cutting
attachments
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
Fit the drive disc (B) on the output shaft.
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head/plastic blades (H) counter
clockwise.
To dismantle, follow the instructions in the reverse
order.
A
H
H
B
C
A
English
11

Publicidad

Tabla de contenido
loading

Tabla de contenido