Num'axes Canicom 250 LE Manual De Instrucciones página 25

Troubleshooting
Should your product stop working or develop a fault, first read this user's guide over, then check the
batteries and replace them if necessary and retry. Also check that you are using the product correctly.
If you encounter any problems, re-code the receiver collar with the remote control (ref. Coding
procedure).
Re-initialize the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 6).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
Restart your CANICOM using the remote control.
If the problem persists, contact your distributor or check out on www.numaxes.com.
You can also contact NUM'AXES at +33.2.38.69.96.27 or by Email export@numaxes.com.
Depending on the extent of the malfunction, you may have to return your product for service and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
If you omit one of these items, the After Sales Service will have to invoice you for any repair costs
incurred.
Gb - 25
Diagram 6
Reset: connect
the 2 supports of
the battery