Switching Left And Right Channel - Pioneer DEH-P88RS Manual De Instrucciones

Section
Audio Adjustments
12
F/B (balance adjustment)—POSI (position se-
lector)—TA1 (time alignment setting)—TA2
(time alignment adjusting)—LOUD (loudness)
—EQ 1 (graphic equalizer)—EQ 2 (16-band
graphic equalizer)—SW 1 (subwoofer on/off)
—SW 2 (subwoofer cut-off frequency)—SW 3
(subwoofer slope)—F.HPF 1 (front high pass
filter slope)—F.HPF 2 (front high pass filter
cut-off frequency)—R.HPF 1 (rear high pass fil-
ter slope)—R.HPF 2 (rear high pass filter cut-
off frequency)—BBE (BBE)—BMX (BMX and
compression)—A.EQ (auto-equalizer on/off)—
ASL (automatic sound levelizer)—SLA (source
level adjustment)
# You can also switch between the audio func-
tions in reverse order by turning
MULTI-CONTROL counterclockwise.
# When tuner, television or AUX is selected as a
source, you cannot select BMX.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# When selecting OFF in TA1, you cannot
switch to TA2.
# You can select SW 2 and SW 3 only when sub-
woofer output output is turned on in SW 1.
# To return to the display of each source, press
BAND.
Notes
! If you do not operate the audio function within
about 30 seconds, the display is automatically
returned to the source display.
! EQ 2 (16-band graphic equalizer), TA2 (time
alignment adjusting), NW 1 (network adjust-
ment 1), NW 2 (network adjustment 2), NW 3
(network adjustment 3) and NW 4 (network
adjustment 4) functions are not canceled
automatically.
56
En
Switching left and right
channel
You can adjust following functions for left and
right channel independently or commonly.
3-way network mode
! Adjusting network (NW 1, NW 2, NW 3)
! Adjusting 16-band graphic equalizer (EQ 2)
Standard mode
! Adjusting subwoofer settings (SW 2)
! Adjusting low pass filter attenuation slope
(SW 3)
! Setting the high pass filter for front speakers
(F.HPF 1, F.HPF 2)
! Setting the high pass filter for rear speakers
(R.HPF 1, R.HPF 2)
! Adjusting 16-band graphic equalizer (EQ 2)
1 Use MULTI-CONTROL to select the
audio function described above.
2 Press MULTI-CONTROL and hold to
switch between left/right independent
mode and left/right common mode.
Each pressing and holding MULTI-CONTROL
selects left/right independent mode and left/
right common mode.
3 Press MULTI-CONTROL to select left
channel or right channel when left/right in-
dependent mode has been selected.
Each pressing MULTI-CONTROL selects left
channel and right channel.
4 Adjust these functions as desired.