Additional Information; Understanding Built-In Cd Player Error; Understanding Auto Ta And Eq Error Messages - Pioneer DEH-P88RS Manual De Instrucciones

Appendix

Additional Information

Understanding built-in CD
player error messages
When you contact your dealer or your nearest
Pioneer Service Center, be sure to record the
error message.
Message Cause
ERROR-11, 12,
Dirty disc
17, 30
ERROR-11, 12,
Scratched disc
17, 30
ERROR-10, 11,
Electrical or me-
12, 15, 17, 30, chanical
A0
ERROR-15
The inserted disc
does not contain
any data
ERROR-23
The CD format
cannot be played
back
No Audio The inserted disc
does not contain
any files that can
be played back
TRK SKIPPED
The inserted disc
contains WMA
files that are pro-
tected by DRM
PROTECT All the files on
the inserted disc
are secured by
DRM
Understanding auto TA and
EQ error messages
When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-
78
En
Action
Clean disc.
Replace disc.
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.
Replace disc.
Replace disc.
Replace disc.
Replace disc.
Replace disc.
pears, refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. After checking, try again.
Message Cause
ERR:MIC check Microphone is
not connected.
ERR:Front The microphone
Speaker, ERR: cannot pick up
Front-Lch, the measuring
ERR:Front-Rch,
tone of a speaker.
ERR:Rear-Lch,
ERR:Rear-Rch,
ERR:SubW-
Lch, ERR:
SubW-Rch,
ERR:SubWoo-
fer
ERR:Outside The surrounding
Noise noise level is too
high.
Action
Plug the supplied
microphone se-
curely into the
jack.
! Confirm that the
speakers are con-
nected correctly.
! Cancel muting
the front speaker
units.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.
! Stop your car in
a place that is as
quiet as possible,
and switch off the
engine, air condi-
tioner or heater.
! Set the micro-
phone correctly.