Turning The Off Clock Display On Or Off; Setting The Fm Tuning Step; Switching Auto Pi Seek - Pioneer DEH-P88RS Manual De Instrucciones

Initial Settings
3 Push MULTI-CONTROL up or down to
set the clock.
Pushing MULTI-CONTROL up will increase
the selected hour or minute. Pushing
MULTI-CONTROL down will decrease the se-
lected hour or minute.
Note
You can match the clock to a time signal by
pressing MULTI-CONTROL.
! If the minute is 00 to 29, the minutes are
rounded down. (e.g., 10:18 becomes 10:00.)
! If the minute is 30 to 59, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
Turning the off clock
display on or off
If the off clock display is turned on, when the
sources and the feature demo are off, the
clock display appears on the display.
1 Use MULTI-CONTROL to select
Off Clock.
Off Clock appears in the display.
2 Press MULTI-CONTROL to turn the off
clock display on.
ON appears in the display.
# To turn the off clock display off, press
MULTI-CONTROL again.

Setting the FM tuning step

Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Use MULTI-CONTROL to select FM step.
FM step appears in the display.
2 Press MULTI-CONTROL to select the FM
tuning step.
Pressing MULTI-CONTROL repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz while AF or TA is on. The selected
FM tuning step will appear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.

Switching Auto PI Seek

The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Use MULTI-CONTROL to select
Auto PI seek.
Auto PI seek appears in the display.
2 Press MULTI-CONTROL to turn Auto PI
seek on.
ON appears in the display.
# To turn Auto PI seek off, press
MULTI-CONTROL again.
Section
13
71
En