External Controls Management; Guard Limits - voestalpine Böhler URANOS 3200 GSM Instrucciones De Uso

3.11 External controls management

Allows the setting of the welding parameters management
method by the external devices (RC, torch...).
Enter set-up by pressing the encoder key for at least 5 seconds.
Select the required parameter (602).
Enter the "External controls management" screen by pressing
the encoder button.
Select the required RC remote control output (CH1, CH2, CH3,
CH4) by pressing button (1).
Select the required parameter (Min-Max-parameter) by pressing
the encoder button.
Adjust the required parameter (Min-Max-parameter) by rotating
the encoder.
Save and exit the current screen by pressing button (4)
Cancel the operation by pressing button (3)

3.12 Guard limits

Allows the welding process to be controlled by setting warning
limits and guard limits
main measurable parameters :
Welding current
Welding voltage
Gas flow
Automation movement
Current Consumption (motor 1)
Current Consumption (motor 2)
Coolant flow
Wire speed
Coolant temperature
50
Enter set-up by pressing the encoder button for at least 5 sec-
onds.
Select the required parameter (801).
Enter the "Guard limits" screen by pressing the encoder button.
Select the required parameter by pressing button (1)
Select the method of setting the guard limits by pressing button
(2) .
/
Absolute value
%
Percentage value
.
.
for the
7 Warning limits line
8 Alarm limits line
9 Minimum levels column
10 Maximum levels column
Select the required box by pressing the encoder key (the select-
ed box is displayed with reverse contrast).
Adjust the level of the selected limit by rotating the encoder.
Save and exit the current screen by pressing button (4)
.
.