Alarms Screen - voestalpine Böhler URANOS 3200 GSM Instrucciones De Uso

Passing one of the warning limits causes a visual signal to appear
on the control panel.
Passing one of the alarm limits causes a visual signal to appear
on the control panel and the immediate blockage of the weld-
ing operations.
It is possible to set start and end of welding filters to prevent
error signals during the striking and extinction of the arc (consult
the "Set up" section - Parameters 802-803-804).

3.13 Alarms screen

Allows the intervention of an alarm to be indicated and provides
the most important indications for the solution of any problem
encountered.
1 Alarm icon
2 Alarm code
3 Alarm type
Alarm codes
E01, E02, E03 Temperature alarm
E05 Current too high alarm
E06 Power module alarm (Boost)
E07 Wire feed motor supply alarm
E08 Blocked motor alarm
E10 Power module alarm
E11, E19 System configuration alarm
E12 Communication alarm (WF - DSP)
E13 Communication alarm (FP)
E14, E15, E18 Program not valid alarm
E16 Communication alarm (RI)
E17 Communication alarm (µP-DSP)
E20 Memory fault alarm
E21, E32 Data loss alarm
E22 LCD display alarm
E29 Incompatible measurements alarm
E30 Communication alarm (HF)
E38 Undervoltage alarm
E39, E40 System power supply alarm
E43 Coolant shortage alarm
E48 Wire out alarm
E49 Emergency switch alarm
E50 Wire stuck alarm
E51 Unsupported settings alarm
E52 Anti-collision alarm
E53 External flow switch alarm
E99 General alarm
Guard limits code
E54 Current level exceeded (Alarm)
E62 Current level exceeded (Warning)
E55 Current level exceeded (Alarm)
E63 Current level exceeded (Warning)
51