Set Up - voestalpine Böhler URANOS 2700 PMC Instrucciones De Uso

2 Welding parameters
2a Welding parameters
Select the required parameter by pressing the encoder
button.
Adjust the value of the selected parameter by rotating
the encoder.
2b Parameter icon
2c Parameter value
2d Unit of measurement of the parameter
3 Functions
Allow the setting of the most important process func-
tions and welding methods.
3a
Allows the selection of the welding process
MMA
TIG DC LIFT START
Standard MIG/MAG
Pulsed MIG/MAG
3b
MIG/MAG - Pulsed MIG/MAG
Allows the selection of the welding method
2 Step
4 Step
Crater filler
40
3c
MMA Synergy
Allows you to set the best arc dynamics,
selecting the type of electrode used:
STD
CLS
CrNi
Alu
Cast iron Cast iron
Selecting the correct arc dynamics enables maximum
benefit to be derived from the power source to achieve
the best possible welding performances.
Perfect weldability of the electrode used is not guaran-
teed (weldability depends on the quality of the consum-
ables and their preservation, the operating and welding
conditions, the numerous possible applications, etc.).
MIG/MAG - Pulsed MIG/MAG
Double pulsed inactive
Double pulsed active
3d
MIG/MAG - Pulsed MIG/MAG
Display type
4 VRD Voltage Reduction Device
Shows that the no-load voltage of the equipment is
controlled.
5 Measurements
During the welding operation, the real current and volt-
age measurements are shown on the LCD display.
5a Welding current
5b Welding voltage

3.6 Set up

Permits set up and adjustment of a series of additional param-
eters for improved and more accurate control of the welding
system.
The parameters present at set up are organised in relation to the
welding process selected and have a numerical code.
Entry to set up: by pressing the encoder key for 5 sec.
Basic/Rutile
Cellulose
Steel
Aluminium