SUHNER ABRASIVE LBC 16-TOP Documentación Técnica página 23

3.1.1 A /d
ttAching etAtching the grinding belt
To change the grinding belt, first disengage the contact
arm.
Loosen setscrew (1). Optimize belt run with knurled screw
(2) and secure with setscrew.
Dismantling the belt grinding attachment according to
Sec. 3.1.2.
Optimize the grinding belt tension with hexagon spanner
and mount the belt grinding attachment again.
Let the tool run without load for at least thirty seconds.
3.1.2 r /
ePlAcing connecting the belt grinding AttAchment
Attach the belt grinding attachment to the drive at the po-
sition you want, and tighten the screw.
3.1.3 r /
ePlAcing connecting the contAct Arm
Loosen the knurled nut. Replace the contact arm, and
retighten the knurled nut.
3.1.4 r /
ePlAcing connection the contAct roller
23