Dyna-Glo DGP552SSP Manual De Instrucciones página 14

ASSEMBLY INSTRUCTIONS
15. Use two M4x10 bolts (BB) to assemble the side
burner valve and the side burner control knob
bezel (H) to the right side burner control panel
(G).
Assemble the ignition wire to the side burner
electrode.
Hardware Used
BB M4x10 Bolt
16. Disassemble two M4x10 bolts and two M4
washers that are pre-assembled on the side
burner (F) and use them to assemble the
side burner (F) on the Right side burner table
assembly (E). Make sure the side burner orifice
is placed into the gas inlet tube of side burner.
place the Side burner cooking grate (D) on the
Right side burner table assembly (E). Assemble
the ignition wire to the side burner electrode.
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 16.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
Incorrect
Incorrect
Correct
Hardware Used
15
BB
M4x10 Bolt
BB BB
x 2
16
14
x2
G
G
H
H
F
2 washers
previously
disassembled
2 bolts previously
disassembled
D
E
F
F
F
E
F
F