Switching The Unit On/Off; Setting The Temperature; Setting The Fan Speed; Setting The Operation Mode - Webasto Cool Top Trail 34 Instrucciones De Operación Y Instalación

5.6

Switching the unit ON/OFF

OFF
Fig. 23: Switching the unit ON
ON
Fig. 24: Switching the unit OFF
5.7

Setting the temperature

Fig. 25: Setting the temperature
5.8

Setting the fan speed

Low Medium
level level
Fig. 26: Setting the fan speed
5.9

Setting the operation mode

COOL DRY FAN
Fig. 27: Setting the operation mode
Cool Top Trail 34
ON
OFF
AUTO
High Automatic
level level
HEAT AUTO
Press the key on the remote control to start the air condi-
X
tioner.
– The unit switches on and the display of the air distributor
shows the set temperature and operation mode.
– The display of the remote control shows the set tempera-
ture, operation mode and fan speed level.
– The previous settings are taken over.
– The indoor fan may start immediately if the unit is in fan
or cool mode. If in heating mode there will be a delay
while the inside coil heats up before the inside fan turns
on - preventing a cold draft.
– It may take up to 3 min. for the compressor to start opera-
tion. This is a feature to protect the compressor.
To switch the unit off, press the
X
– The unit switches off, the display of the air distributor
blanks.
– The display of the remote control shows only the clock.
It is alternatively possible to start and stop the air conditioner
by pushing the touch key
5.17 for more details.
Use the / keys to change the set temperature.
X
– The display of the remote control as well as the display of
the air distributor will show the set temperature.
– The air conditioner will confirm the receipt of each set
value change with a beep.
– You may set the temperature between 16 and 30°C while
the unit is running.
– In FAN
mode no temperature setting is possible.
Use the key to set the fan speed level.
X
FAN
– The fan speed level will directly influence the air flow
volume.
– Each push on the FAN key changes the fan level in the
sequence as shown in Fig. 26.
AUTO indicates that the Automatic FAN mode is selected. In
this mode the fan speed adapts automatically. Automatic FAN
mode is only available in operation mode COOL or HEAT.
Press the key on the remote control to change the opera-
X
MODE
tion mode. The remote control shows the selected symbols
– Each push on the
MODE
quence as shown in Fig. 27.
key again
at the air distributor, see chapter
key changes the mode in the se-
15