Sending A Fax - Canon imageRUNNER ADVANCE C9280 PRO Guía De Usuario

Sending a Fax

This section describes the fl ow of basic fax operations. An optional product is required to use the Fax function.
1
Placing Originals
●
Place the original on the feeder or
the platen glass.
2
Selecting Function
●
Select [Fax] from the Main Menu
screen.
•
Press [Fax].
3
Specify the Destination
●
Enter the fax number.
4
Start Sending the Fax
●
After specifying the settings,
press .
•
If a log in screen for Department ID Management or SSO-H appears, you must enter the applicable authentication information (ID, password/PIN). If the
Copy Card Reader-F1 is attached, fi rst insert a control card.
•
If a login service, such as Department ID Management or SSO-H has been set, press
•
The send settings for the last send job may be retained.
-
To cancel the settings, press
-
The specifi ed destinations are not retained.
2
Placing originals in the feeder
•
Adjust the slide guides to fi t the size of your
originals. Neatly place your originals with the
side to be copied face up.
•
Fax Basic Features Screen is displayed.
•
Enter the fax number using the numeric keys.
•
Press .
.
Placing originals on the platen glass
•
Open the feeder.
•
Place your originals face down.
You can set various facsimile functions. For more
information, see e-Manual > Fax.
After a job is sent, the send settings may be
retained except the specifi ed destinations.
•
To cancel the settings, press
•
To send other jobs with the same settings,
specify destinations for the jobs as the
destination specifi ed for the previous job is not
retained.
(Log In/Out) to log out.
Flow of Basic Operations
.
43