PEERLESS SmartMount SA770PU Instalación Y Ensamblaje página 8

Remove two M5 x 20 mm screws from the rollbrake. Lift
3
adapter plate out from tilt bracket as shown.
NOTE: M5 X 25 mm screw may need to be loosened a
few turns to allow adapter bracket to be removed using
4 mm allen wrench (N).
Installing Universal Adapter Bracket to Screen
NOTE: If your screen has a VESA hole pattern skip to page 13.
4
Using the hole pattern shown in detail 2, attach the adapter plate to universal adapter
bracket (B) or dedicated adapter plate with four M10 x 15 mm screws (G) as shown.
Tighten screws using 6 mm allen wrench (K).
B
4-1
Fasten two screen brackets (C) to the gliders on
phillips screws (H) as shown in fig. 4.1.
Visit Peerless website at www.peerlessmounts.com
ADAPTER PLATE
ADAPTER PLATE
G
fig. 4.1
ADAPTER
PLATE
TILT
BRACKET
DEDICATED
ADAPTER PLATE
universal adapter bracket (B)
B
H
C
8 of 45
For customer care call 1-800-729-0307 or 708-865-8870
M5 X 20 MM
SCREW
ROLL BRAKE
A
M5 X 25 MM
SCREW
LARGE
HOLES
HOLE PATTERN
FOR USE WITH
UNIVERSAL
ADAPTER
BRACKET OR
DEDICATED
ADAPTER PLATE
G
DETAIL 2
using four M5 x 10 mm flat head
GLIDERS
ISSUED: 05-16-08 SHEET #: 095-9285-1