cecotec HidroBoost 1600 Car&Bike Manual De Instrucciones página 24

ENGLISH
This appliance offers 3 modes:
FOCUSED MODE
The angle of the water jet coming out of the nozzle may
be adjusted with the pulverizing nozzle. Turn the nozzle to
select the focused stream, which has a high impact on the
cleaning surface and results in maximum deep cleaning in
a concentrated area. This narrow high-impact stream must
be used cautiously, as it may damage some surfaces.
NOTE: Pay special attention when cleaning delicate surfaces such as bodywork o wheel rims,
lacquered surfaces, wood, paint, etc.
SPRAY MODE
Turn the pulverizing nozzle to select the flat-fan pattern. A
wide stream will distribute the impact of water over a larger
area, resulting in excellent cleaning action with a reduced
risk of surface damage. Large surface areas can be cleaned
more quickly using a wider stream.
TURBO MODE
Use the 3D TurboFlip nozzle to clean with turbo mode. Water
is distributed in a spiral-shaped stream. The 3D TurboFlip
nozzle combines the power of a focused high-impact
stream and the efficiency of a 25-degree stream. This turns
the narrow high-impact stream into a cone-shaped one that
cleans thoroughly larger areas.
PRODUCT OPERATION
NOTE: The motor on this pressure washer does not run continuously. It only runs when the
trigger of the spray gun is squeezed. After following the start-up procedures in this manual,
turn the pressure washer on and squeeze the trigger for activation.
NOZZLE CLEANING
A clogged or partially clogged nozzle can cause a significant reduction of water coming out of
the nozzle and cause the unit to pulsate while spraying. To clean out the nozzle:
• Turn off and unplug the unit.
• Turn off water supply. Relieve any pressure trapped in the high-pressure by squeezing
the trigger 2-3 times.
24 HIDROBOOST 1600 CAR&BIKE