Cleaning And Maintenance; Troubleshooting - cecotec HidroBoost 1600 Car&Bike Manual De Instrucciones

ENGLISH
• Turn the water supply off.
• Once the power and water supply are turned off, press the trigger to depressurize the
device.
WARNING:
• Do not turn the water supply off before turning the motor off. Serious damage could occur
to the pump and or motor.
• Do not disconnect the high-pressure hose from the machine while the device is
pressurized. To depressurize, turn motor off, turn water supply off and squeeze gun
trigger 2-3 times.
TIPS FOR EXTENDING THE PRODUCT'S SERVICE LIFE
• Never operate unit without water.
• Do not use the device with hot water.
• Before adjusting the pulverizing nozzle's pressure (high-to-low or low-to-high) release
trigger.
• Never operate unit for more than one minute without spraying water.

5. CLEANING AND MAINTENANCE

• Use exclusively specific cleaning agents for pressure washers.
• The machine shall be disconnected from its power source by removing the plug from the
socket-outlet during cleaning or maintenance.
• Do not store the pressure washer outdoors or where it could freeze. The pump could be
seriously damaged.

6. TROUBLESHOOTING

PROBLEM
No soap suction.
28 HIDROBOOST 1600 CAR&BIKE
CAUSE
• The nozzle is not at low
pressure.
• The high-pressure
extension hose or hose is
too long.
• The pump injector is
clogged.
• The soap bottle is
clogged.
SOLUTION
• Turn the nozzle to the low-
pressure position.
• Remove the high-pressure
extension hose or use a
shorter one (less than 7 m).
• Contact the Technical Support
Service of Cecotec.
• Clean the accessory with warm
water or replace the accessory.