cecotec HidroBoost 1400 EasyMove Manual De Instrucciones página 23

• Remove debris by back-flushing water through the nozzle. To do this, point the end of a
garden hose (with water running) to the nozzle's end for 30-60 seconds.
ANGLE FROM THE HIGH-PRESSURE HOSE TO THE CLEANING SURFACE
When spraying water against a surface, maximum impact is reached when the water strikes
the surface head on. However, this type of impact tends to cause dirt particles to imbed in the
surface, thereby preventing the desired cleaning action.
The optimum angle for spraying water against a cleaning surface if 45 degrees.
Spraying water against a surface at this angle provides for the most beneficial impact force
combined with efficient removal of debris from the surface.
DISTANCE FROM CLEANLING SURFACE
The impact force of the water is increased as the pulverizing nozzle is moved closer to the
surface.
HOW TO AVOID DAMAGING SURFACES
Damage to cleaning surfaces occurs because the impact force of the water exceeds the
hardness of the surface. The impact force can be varied by controlling the three previously
noted items. Never use a narrow high impact stream on a surface that is susceptible to damage.
Avoid spraying windows with a narrow high impact stream as this may cause breakage.
The surest way to avoid damaging surfaces is to follow these steps:
• Before triggering the gun, adjust the pulverizing nozzle to a wide stream.
• First, follow the distance and angle instructions above.
• Vary the spray angle, stream type and the distance to the cleaning surface until optimum
cleaning efficiency is achieved without damaging the surface.
3D TURBOFLIP NOZZLE
A 3D TurboFLip nozzle, sometimes referred to as a rotary nozzle, is a very effective accessory
that can significantly reduce cleaning time. This is the accessory that must be attached to use
the turbo mode explained in the before section.
HIDROBOOST 1400 EASYMOVE
ENGLISH
23