Troubleshooting - cecotec HidroBoost 1400 EasyMove Manual De Instrucciones

socket-outlet during cleaning or maintenance.
• Do not store the pressure washer outdoors or where it could freeze. The pump could be
seriously damaged.

6. TROUBLESHOOTING

PROBLEM
Smoke comes out
from the device.
Not enough
pressure.
The pressure
washer does not
start up.
Fluctuating
pressure.
CAUSE
Overheating, overload or
damaged motor.
• Water inlet filter is
clogged.
• Air from the hose
connections is entering
the pump.
• The nozzle or relief valves
are worn or not the
correct size.
• The unit is pressurized.
• Plug is not well connected
or electric socket is
defective.
• Extension cord is too long
or wire size too small.
• Main voltage supply is
too low.
• Thermal safety switch
has tripped.
• Pump is sucking in air.
• Clogged nozzle.
• Valves dirty or worn.
• Water seals worn.
SOLUTION
Turn the device immediately of
and contact the Technical Support
Service of Cecotec.
• Clean the water inlet filter.
• Check that connections and
locking ring are properly
tightened.
• Contact the Technical Support
Service of Cecotec.
• Squeeze trigger on gun.
• Check plug, socket and fuse.
• Remove extension cord.
• Check that main supply
matches the voltage stated on
the product's rating label.
• Switch the device off and allow
it to cool down.
• Check that hoses and
connections are tight.
• Clean with the cleaning kit
• Contact the Technical Support
Service of Cecotec.
• Contact the Technical Support
Service of Cecotec.
HIDROBOOST 1400 EASYMOVE
ENGLISH
25