Hitachi CR 13VB Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
CAUTION:
When pulling the saw blade, be
absolutely sure to pull it from the
back. Pulling other parts of the
blade will result in an injury.
7. Dismounting the blade
(1) Turn on and off the switching trigger
several times so that the lever can
jump out of the front cover
completely. Thereafter, turn off the
switch and unplug the power cord.
(Fig. 2)
CAUTION:
Be absolutely sure to keep the switch
turned off and the power cord
unplugged to prevent any accident.
(2) After you have pushed the lever in
the direction of the arrow mark
shown in Fig. 3, turn the blade so it
faces downward. The blade should
fall out by itself. If the blade doesn't
fall out, pull it out by hand.
CAUTION:
Never touch the saw blade
immediately after use. The metal is
hot and can easily burn your skin.
WHEN THE BLADE IS BROKEN
Even when the saw blade is broken and
remains inside the small slit of the
plunger, it should fall out if you push the
lever in the direction of the arrow mark,
and face the blade downward. If it doesn't
fall out itself, take it out using the
procedures explained below.
(1) If a part of the broken saw blade is
sticking out of the small slit of the
plunger, pull out the protruding part
and take the blade out.
(2) If the broken saw blade is hidden
inside the small slit, hook the broken
blade using a tip of another saw
blade and take it out. (Fig. 8)
10
Another blade
MAINTENANCE AND INSPECTION
OF SAW BLADE MOUNT
(1) After use, blow away sawdust, earth,
sand, moisture, etc., with air or brush
them away with a brush, etc., to ensure
that the blade mount can function
smoothly.
(2) As shown in Fig. 9, carry out lubrication
around the blade holder on a periodic
basis by use of cutting fluid, etc.
Blade holder
Lever
NOTE:
Continued use of the tool without
cleaning and lubricating the area
where the saw blade is installed can
result in some slack movement of
the lever due to accumulated
sawdust and chips. Under the
circumstances, pull a rubber cap
provided on the lever in the
direction of an arrow mark as shown
in Fig. 10 and remove the rubber cap
from the lever. Then, clean up the
inside of the blade holder with air
and the like and carry out sufficient
lubrication.
The rubber cap can be fitted on if it
Lever
Slit of plunger
Fig. 8
Machine oil
Fig. 9

Publicidad

Tabla de contenido
loading

Tabla de contenido