Before Use; Operation - Hitachi DN 18DSL Manual De Instrucciones

NOTE
Charging times may be longer depending on the
surrounding temperature and battery conditions.
Remove the battery from the charger when not in
use.

BEFORE USE

Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.

OPERATION

1. Mounting and dismounting of the bit.
(1) Mounting the bit.
At first, remove the the battery from the tool.
Loosen the sleeve by turning it toward the left (in
the counterclockwise direction as viewed from the
front) to open the clip on the keyless chuck. After
inserting a driver bit, etc., into the keyless drill
chuck, and tighten the sleeve by turning it toward
the right (in the clockwise direction as viewed from
the front). (See Fig. 6).
Loosen
Tighten
NOTE
If the sleeve becomes loose during operation,
tighten it further.
The tightening force becomes stronger when the
sleeve is tightened.
(2) Dismounting the bit
At first, remove the the battery from the tool.
Loosen the sleeve by turning it toward the left (in
the counterclockwise direction as viewed from the
front), and then take out the bit etc. (See Fig. 6)
CAUTION
When mounting a bit into the keyless chuck,
tighten firmly. If the sleeve is not tight, the bit may
slip or fall out, causing injury.
NOTE
When it is no longer possible to loosen the sleeve,
use a vise or similar instrument to secure the bit.
Turn the sleeve to the loose side (left side) for a
moment. It should be easy now to loosen the
sleeve.
Sleeve
Fig. 6
2. Confirm that the battery is mounted correctly.
3. Installing the side handle.
Screw the side handle into the gear cover tightly.
(Fig. 7)
Gear cover
4. Check the rotational direction.
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the selector button.
The L-side of the selector button is pushed to turn
the bit counterclockwise (See Fig. 8).
(The and marks are provided on the body.)
L R
Trigger switch
mark
R
When the trigger switch is depressed, the tool
rotates. When the trigger switch is released, the
tool stops.
The rotational speed of the drill can be controlled
by varying the amount that the trigger switch is
pulled. Speed is low when the trigger switch is
pulled slightly and increases as the trigger switch
is pulled more.
When releasing the trigger switch, the brake will
be applied for immediate stopping.
CAUTION
●
The motor rotation may be locked to cease while
the unit is used as drill. While operating the angle
drill, take care not to lock the motor.
●
If the motor is locked, immediately turn the power
off. If the motor is locked for a while, the motor or
battery may be burnt.
●
A buzzing noise is produced when the motor is
about to rotate; This is only a noise, not a machine
failure.
English
Tighten
Side handle
Loosen
Fig. 7
mark
L
Selector button
Fig. 8
13