Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
5.
About Remaining Battery Indicator
When pressing the remaining battery indicator
switch, the remaining battery indicator lamp lights
and the battery remaining power can be checked.
When releasing your finger from the remaining
battery indicator switch, the remaining battery
indicator lamp goes off. The Table 4 shows the
state of remaining battery indicator lamp and the
battery remaining power. (see Fig. 1)
State of lamp Battery Remaining Power
The battery remaining power
is enough.
The battery remaining power
is a half.
The battery remaining power
is nearly empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows
somewhat differently depending on ambient
temperature and battery characteristics, read it as
a reference.
NOTE:
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
6.
Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
●
When using the hook, hang up the power tool
firmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
●
When carrying the power tool with hooked to your
waist belt, do not fit any bit to the tip of power
tool. If the sharp bit such as drill is fitted to the
power tool when carrying it with hooked to your
waist belt, you will be injured.
●
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
(1) Installing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fix the hook firmly.
(Fig. 9)
Hook can be installing either side of the body.
14
Table 4
Body
Hook
7.
Using the light
Pull the trigger switch to light up the light. The light
keeps on lighting while the trigger switch is being
pulled. The light goes out after releasing the trigger
switch. (Fig. 10).
Trigger
Switch
CAUTION
Do not look directly into the light. Such actions
could result in eye injury.
OPERATIONAL CAUTIONS
1.
Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous drilling or tightening wood screw work
may cause the temperature of the unit to rise,
activating the temperature protection circuit and
automatically stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous tightening wood screw
works, rest the unit for 15 minutes or so when
replacing the battery. The temperature of the
motor, switch, etc., will rise if the work is started
again immediately after battery replacement,
eventually resulting in burnout.
Groove
Screw
Fig. 9
Fig. 10
Publicidad
Tabla de contenido
