Attaching The Flue Duct - Gaggenau AW 2 Serie Instrucciones De Uso

Connecting the pipes
Note: If using an aluminium pipe, smooth the
connection area beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe
connector and seal.
Exhaust-air pipe Ø 120 mm
1 Attach the reducing connector directly to the air-
pipe connector.
2 Attach the exhaust air pipe to the reducing
connector.
3 Seal both joints appropriately.
26

Attaching the flue duct

m
Risk of injury!
From sharp edges during installation. Always wear
protective gloves while installing the appliance.
1 Separate the flue ducts.
To do this, remove the adhesive tape.
2 Remove the protective foil from both flue ducts.
3 Push one flue duct into the other.
Notes
‒ To prevent scratches, lay paper over the edges
of the lower flue duct to protect the surface.
‒ Slots of the inner flue duct point downwards.
4 Place flue ducts on the appliance.
5 Push the inner flue duct upwards and attach it to
the fixing brackets on the left and right.
6 Press the flue duct downwards until it engages.
7 Screw the flue duct to the sides of the fixing
bracket using two screws.
¨
©
ª