12 Carefully remove the protective foil.
Avoid damage to the sensitive surface.
Warning: The interior walls of the flue panelling can
have sharp edges – Risk of injury –.
We recommend that you wear gloves when
installing.
13. Insert the upper flue duct into the lower flue
duct.
Protect the cover panels from scratches,
for example by laying the template used for
marking the wall over the top edge of the lower
section.
14. Insert the complete flue duct at an angle and
swivel to the rear.
15 Carefully pull the upper flue duct upwards and
screw the sides to the fixing bracket with
2 screws.
16 Insert the grease filter (refer to Operating
Instructions).
17 Place the glass plates on the appliance with the
printed side facing down.
Note: when putting the glass trays in place, make
sure that you do not scratch the chimney.
19