Heath Zenith 5514 Manual De Instrucciones página 3

Bulb Installation and Replacement
CAUTION: When replacing bulbs, turn power
off and let the fixture cool.
Important: Use a clean glove or cloth when handling
the new bulb. Use isopropyl (rubbing) alcohol to clean
the bulb if it is touched with your bare hands.
NOTE: Bulbs are included, but need to be installed.
The bulbs are located behind the glass cover of
each lamp head.
1. Open lamp head with a phillips head screwdriver.
To remove the old bulb, push the bulb towards the
right until the left side of the bulb is clear of the left
socket.
2. To install the bulb, place one end of the bulb on the
contact in the right socket. While pushing the bulb
against the right contact, lower the other end of the
bulb onto the contact in the left socket.
3. Spin the bulb to verify it is seated properly.
4. Close the lamp head and tighten locking screw
securely.
Bulb
Left
Socket
Contact
2
595-5730-07
Lamp Head
1
Right
Socket
Glass
Cover
Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
1. Remove the existing light fixture.
2. Install mounting strap to junction box using screws
appropriate for your junction box.
3. The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
4. Thread all fixture wires through the large holes in
the gasket as shown.
5. Connect the junction box wires to the light fixture
wires as shown. Twist together and secure with
wire connectors.
CAUTION: Do not cut any wires with factory
installed wire connectors.
White to White
Mounting Strap
Gasket
Black to Black
Connect green or bare copper wire(s) in the fixture
to green ground screw and ground wire in junc-
tion box. Note: All ground wires shown as green
in above illustration.
3