Midea MRT18S2AWW Manual De Usuario página 16

9.
Slide the hose through the hole of the
security bracket and the foam insulation
pad, with the pad facing the rear of the
refrigerator and affix the hose security
bracket and foam insulation pad in place
using the two (2) screws provided.
10.
Push the water supply hose into the water
inlet hose as far as it will go and tighten the
Nylon compression nut onto the water inlet
hose until it is secure/tight.
Then tighten the nut until it is secure but DO
NOT overtighten using a wrench.
11.
Install the leveling bracket to the bottom
of the ice maker assembly with the screw
provided.
DO NOT TIGHTEN.
This bracket will be tightened later in this
installation.
12.
Start two (2) long ice maker mounting
screws into the freezer wall.
Turn each screw five turns clockwise.
13.
With the ice maker in one hand, plug the
wiring harness connector into the connector
mounted on the top freezer panel.
Make sure the connection is tight and secure.
16
(11)Water
Inlet Tube
(3)Water
Tubing
Leveling
Bracket(7)
Screw(6)
(5) Ice Maker
Mounting Screws
Wiring Harness
Connector