Replacing The Fuse; Technical Specifications - EuroLite WF-250 Manual Del Usuario

There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamps".

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Dimensions (LxWxH):
Weight:
Fitting lamp:
OMNILUX ELC 24V/250W GX-5,3 50h 50mm
OMNILUX ELC 24V/250W GX-5,3 500h 50mm
GE ELC 24V/250W GX-5,3 50h 50mm
OSRAM ELC 64653HLX A1/259 24V/250W
PHILIPS ELC 24V/250W GX-5,3 50h 50mm
PHILIPS ELC 24V/250W GX-5,3 500h 50mm
Maximum ambient temperature t
Maximum housing temperature t
Fuse:
Please note: Every information is subject to change without prior notice. 30.11.2005 ©
230 V AC, 50 Hz ~
280 W
240 x 255 x 170 mm
6 kg
Article Nr.:
88264005
88264105
88264000
88264010
88264015
88264115
: 45° C
a
(steady state): 90° C
B
T 2 A, 250 V
18/33 51799330_V_3_0.DOC