Beurer UB 65 Instrucciones Para El Uso página 9

• When the electric underblanket is switched on
– no object (e.g. bag or washing basket) must be placed on it;
– no source of heat such as a hot-water bottle, heat pad etc. must be placed on it;
– the switch must not be covered by blankets, pillows etc. or be placed on the blanket.
• Do not pull, twist or sharply bend the cables.
• Do not pierce the electric underblanket with needles or pointed objects.
• This heated underblanket should only be operated with the switch indicated on the electric under-
blankets (label).
• This electric underblanket must not be used by children unless the switch has been preset by their
parents or carers, or the child has been adequately instructed in how to use the electric underblanket.
• Children should be supervised to ensure that they do not use the electric underblankets as a toy.
• The electric underblanket must be checked frequently for signs of wear or damage. If any such
signs are found or if the blanket has been improperly used, it must be sent in to the manufacturer
or dealer before it is used again.
• Repairs must be carried out only by skilled persons or a repairer authorized by the manufacturer,
as special tools are required. Improper repairs can result in considerable danger to users.
• If you have any further questions concerning the use of our products, please contact our customer
service or visit our website www.beurer.de/FAQ.81.0.html
2. Proper Use
This electric underblanket is intended for warming beds. The electric underblanket heats up best
when it is switched on when covered with a quilt. The heating up time with the electric underblanket
covered is approx. 30 minutes. You can use either side of the electric underblanket.
3. Operation
3.1 Safety
The electric underblanket is fitted with the BEURER SAFETY SYSTEM (BSS). This electronic sensor
technology prevents the blanket from overheating over its entire surface by switching it off automa-
tically in the event of a fault. If, as a result of a fault, the electric underblanket is switched off auto-
matically by the Beurer Safety System (BSS), the signal lamp will no longer light up even when the
blanket is switched on. Please note that for safety reasons the electric underblanket must no longer
be operated after a fault and must be sent in to the service address stated.
3.2 Putting into operation
Spread out the heated underblanket flat on your mattress so that the cable entry
is located at approximately shoulder height (see illustration). The head section is
not heated.
Then pull the side section over the sides of your mattress like a fitted sheet. The
underblanket is designed to fit mattresses in sizes 35x80 in (90x200 cm) and
38x80 in (100x200 cm).
Then secure your fitted sheet as usual so that the heated underblanket is bet-
ween your mattress and the fitted sheet.
Make sure that the heated underblanket is always spread out flat and does not
ruckle or crease after use. Check its position when making the bed. The heated
underblanket should only be switched on if it is spread out flat. We recommend
switching on the underblanket approx. 30 minutes before going to bed and cove-
ring it with the quilt to prevent the heat from escaping.
Attention: The electronic components in the switch will cause the switch to warm up slightly
when the electric underblanket is being used. For this reason, the switch must never lie on the
electric underblanket or be covered by blankets, pillows etc.
9