EINHELL TC-SM 2131/1 Dual Manual De Instrucciones Original página 38

Caution - Read the operating instructions to reduce the risk of inquiry.
Wear ear-muff s. The impact of noise can cause damage to hearing.
Wear a breathing mask. Dust which is injurious to health can be generated when working on wood
and other materials. Never use the device to work on any materials containing asbestos!
Wear safety goggles. Sparks generated during working or splinters, chips and dust emitted by the de-
vice can cause loss of sight.
Caution! Risk of injury! Do not reach into the running saw blade.
Warning! The adjustable stop rails are secured by hex screws.
To make miter cuts (with the saw head inclined or the turntable set at an angle), the adjustable stop rails
must be fi xed at an outer position.
For 45° crosscuts to the left, the left stop rail must be pushed outwards and screwed tight.
For 45° crosscuts to the right, the right-hand stop rail must be pushed outwards and screwed tight.
To make 90° crosscuts, the adjustable stops rail must be fi xed at the inner position!
Anl_TC_SM_2131_1_Dual_SPK8.indb 38 Anl_TC_SM_2131_1_Dual_SPK8.indb 38
GB
- 38 -
09.07.2020 11:13:37 09.07.2020 11:13:37