Broan CJD1 Series Instrucciones De Instalación página 4

PREPARE THE HOOD
3 Remove
Damper/Duct
Connector
from inside
the hood. Set
connector
aside - with
mounting
screws and
parts bag.
DAMPER/
DUCT
CONNECTOR
4 Remove Wiring
Cover from
inside the hood.
Set cover and
mounting screw
aside.
WIRING
COVER
5 Remove either
top or back
wiring knock-
out and install
approved
Electrical
Cable Clamp
(not included).
Non-Ducted Installation - Skip to "CONNECT
THE WIRING" .
The following
Steps (6 thru
13) are for
DUCTED
INSTALLATION
ONLY.
Remove Light Panel - held in place with (3) #8 screws
6
and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
ELECTRICAL CABLE CLAMP
(3) #8 SCREWS
(2) #8 SCREWS
PREPARE THE HOOD
Remove Air
7
Chute - held in
place with one
(1) screw.
NOTE: Be
careful not to
disconnect any
wires.
AIR CHUTE
Remove Baffle
8
from air chute.
9 Rotate baffle. Re-
insert baffle into air
chute (as shown) so
that baffle tabs fit all
LIGHT
the way into slots in
PANEL
air chute. An audible
"click" will be heard
when fully installed.
This will close off
the air flow through
the non-ducted slots
on top of hood.
10 Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between support fin and light panel.
CJD1 SERIES
BAFFLE
BAFFLE
TABS
SLOTS
SUPPORT FIN
Page 4