Cleaning & Maintenance - Broan CJD1 Series Instrucciones De Instalación

NON-DUCTED FILTERS
If hood is to be installed Non-Ducted:
Purchase a set of (2) Non-Ducted Filters from your local
distributor or retailer and attach them to the aluminum mesh
filters.
NOTE: For models that are installed in the non-ducted mode,
the most effective operation is achieved at speeds 1 and
2. These speeds provide the most efficient and quiet
operation during cooking, while maximizing the benefits
of the recirculating filtration system.
OPERATION
Always turn the hood ON before cooking in order to establish an air
flow in the kitchen. After turning off the range, let the hood run for a
few minutes to clear the air.
This range hood is equipped with the latest in capacitive touch tech-
nology. The buttons do not move, but are touch sensitive. When a
touch is understood, the control will emit a sound.
FAN
1. Touch fan button to turn fan on to low speed.
2. Touch fan button again for high speed and fan off.
The light ring around the button will illuminate when fan
is on - a dim glow for low speed and a brighter glow for
high speed.
LIGHT
1. Touch light button to turn light on to dim setting.
2. Touch light button again for bright and light off.
The light ring around the button will illuminate when light
is on - a dim glow for dim light setting and a brighter
glow for bright light setting.
FILTER CLEAN
The fan light ring will flash when it is time to clean or replace the
filter, based on your individual use pattern.
To reset filter clean reminder indicator, touch and hold the fan
button for three seconds.
CLEANING & MAINTENANCE
WARNING: To reduce the risk of electric shock, discon-
nect from power supply before cleaning.
Aluminum mesh filters: Clean frequently using hot water and a
mild detergent. Filters are dishwasher safe.
Charcoal filters: Clean filter surfaces frequently with a damp cloth
and a mild detergent. DO NOT immerse filters in water or put in dish-
washer. The special "Clean Sense" feature indicates when the filter
is to be replaced. The dotted lines on the indicator strip will change
to solid wide lines when it is time to change the filter. The "Clean
Sense" feature works best when facing toward the cooking surface.
To clean hood: Remove filters. Use a damp cloth and a mild
detergent to wipe all grease-laden surfaces. Do not use abrasive
cloth, steel wool pads, or scouring powder on any painted surface.
Use care when cleaning blower wheel - it must not become bent or
misaligned. DO NOT ALLOW WATER TO ENTER MOTOR. Make
sure all surfaces are completely dry before re-installing filters and
restoring power.
Motor is permanently lubricated. Do not oil or disassemble motor.
CJD1 SERIES
Page 2